Most of the time, businesses will spend lots of money to purchase their forklifts. It is important, therefore to take proper care of your machine to protect your investment into the long run. It is a good idea to know the procedures that are carried out in taking care of and maintaining this machinery.
By starting up the forklift and listening carefully how it runs is amongst the best ways to tell how good the engine is working. For instance, if there are any knocks or misses, the machinery is faulty and this should raise some issues. Furthermore listen closely for any squealing noise which come from the belts since these sounds would provide you with a lot of information.
When carrying out maintenance, several of the main parts you would need to pay attention to consist of the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals should be cleaned when the above components have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each and every battery cell needs to be checked so as to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been completed and new filters have been fitted, visually check the drive axle from underneath the equipment. Be certain to grease the axle if there is any grease fitting. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. After that, check each and every other part of the machine including the wheels. If any type of issue or fault is detected, be certain to deal with it immediately in order to make sure the machine is working at its safest and optimum levels.